Wave Rural’s Arris VIP5662W
Top And Front Panel
Key |
Item |
Function |
1 |
POWER BUTTON |
Press to turn the wireless receiver on or place the unit in standby mode.If held for five(5) seconds or longer, restarts the wireless receiver. |
2 |
SIGNAL STRENGTH |
The five-bar display lights green to indicate signal strength from your wireless Access Point device. The number of bars that light reflect the strength of the received signal. The more bars, the stronger the signal. See the Troubleshooting section for details. |
3 |
LINK |
Lights green when the ethernet is connected. |
4 |
BLUETOOTH |
Lights blue when the remote control unit is paired with the wireless receiver. |
5 |
RECORD |
Lights red when a recording is in progress. |
|
|
|
Rear Panel
Key |
Item |
Function |
1 |
POWER +12 VDC |
Connector for the DC power adapter specified for this VIP5662W. |
2 |
NETWORK |
Ethernet 10/100 Base-T RJ-45 port. Link LED : lights when connected to video service. Bluetooth LED : blinks when the wireless receiver searches for a Bluetooth remote control unit within range. |
3 |
RESET BUTTON |
Press and release to trigger the System Recovery Process. |
4 |
OPTICAL |
TOSLink (S/PDIF) digital audio output. |
5 |
BREAKAWAY CABLE |
Alternative method for video/audio connections.Offers analog component, composite, and stereo audio outputs. |
6 |
HDMI OUT |
Connects to a High Definition TV or home theater receiver with an HDMI input (for a DVI input, use an HDMI-to-DVI adapter). |
7 |
USB 3.0 |
Allows connectivity with USB 3.0 devices. |
8 |
BLUETOOTH PAIRING |
Press and release to initiate Bluetooth remote control unit pairing with wireless receiver. Hold the button for 10 seconds to unpair the bluetooth remote control unit and the wireless receiver. |
Wireless Connection
As shown in the diagram below, programs and services for the VIP5662W are transmitted over the air from a wireless Access Point. The Access Point, in turn, is connected to your home network gateway device.
The Access Point can transmit separate programming streams to as many as five wireless IPTV Receivers. The Access Point uses Wi-Fi Protected Setup (WPS) protocols to identity, authorize, and manage traffic to and from its client devices.
Register the TV Receiver with the Access Point
Before your TV Receiver can receive any programming, it must be registered as an authorized device with the Access Point. Run the WPS procedure as follows:
- Connect the cord from the DC Power Adapter to the POWER +12VDC connector on the rear of the VIP5662W, and plug the adapter into an AC wall socket. Then connect the VIP5662W to your TV set.
- The Power button on the front of the wireless TV receiver lights green to indicate power is applied.
- Ensure that the Access Point is connected to your home gateway device, and that power is applied to it.
- When the TV receiver starts up, it will look for a signal from an Access Point. When it detects the signal, a prompt will appear on your TV screen asking if you wish to connect.
- On the remote control unit, press the OK or Select button.
- On the Access Point, press and hold the WPS button on the front panel for two seconds, then release to activate the WPS process.
- An icon appears on the TV screen, indicating that the connection sequence is in process. When three horizontal dots appear, the connection has been successful.
- On the front panel of the VIP5662W, two or more bars on the signal strength indicator should light green. You have now established a secure wireless connection between the Access Point and your VIP5662W.
NOTE: To install additional wireless TV receivers, repeat steps 1-7.